Do I enter tariff prices with or without VAT?

  • Tested on firmware v1.1.4
  • Getting started

Written for firmware v1.1.4. The current release is v1.2.1, so some details may differ.

Without VAT. On the Tariffs page, every buy price and each of the three per-kWh charges — energy tax, grid fee, renewable levy — is entered net. The hub applies VAT % itself, on top of all of them.

Why it matters more than it sounds

Your supplier's price sheet usually shows the VAT-inclusive price on the front and the components in the small print. If you type the inclusive figure and fill in VAT %, every cost the hub records is too high by your VAT rate — and nothing warns you. You'd find out by comparing with a bill months later.

What the hub does with the numbers

cost = ( kWh × zone price + kWh × (energy tax + grid fee + renewable levy) ) × (1 + VAT / 100)

A measured example, from a hub running this plan: a night price of 0.18, charges totalling 0.08, VAT 20 %. The hub reports an all-in price of 0.312 €/kWh — ( 0.18 + 0.08 ) × 1.20. In the day zone, at 0.32, it reports 0.48.

The one exception: the setup wizard

The wizard's quick tariff step has a switch, Price as on the bill — incl. VAT. Leave it on if you're typing the price your bill shows, and the wizard does the conversion. That switch exists only in the wizard; the Tariffs page always wants net prices.

How to check you got it right

Compare the hub's all-in price for a zone against the per-kWh total on your bill. If the hub's figure is higher by roughly your VAT rate, you entered gross prices into the Tariffs page.

Next